killagt

iTrader: (3)

I just install new Seat Belt Guides, I need to take out the seat belt, to put it thru the seat belt guides. Any one have any ideal ? thanks

slayerized6

iTrader: (12)

your need a torx bit on a socket wrench to remove one bolt on the floorboard bewteen the seat and the door. then just slide the belt through the new guide and bolt it back up.

my bandit

iTrader: (10)

yup exactly what he said. im 99% sure its a 45 torx. i just beat a 50 into mine b/c i was too cheap at the time...and i had no seat in haha

killagt

iTrader: (3)

When I look at the bottem of the seat belt, I saw some kind of cap with the cross mark, how do I take off that cap ? thanks

Update : I just did a search and found this, Every thing I need to know how to remove and install, seat belt and guide. For future NOOB, here is the link.

http://www.ls1.com/forums/showthread.php?t=59696

wssix99

iTrader: (5)

To get the cap off, (over the torx bolt) pry one side up with a screw driver and then turn the cap with a Quarter inserted in one of the slots. If you look at the pictures in the write up, you'll see there is a break in the flange that holds the cap down. When it hits the area you are prying, it should twist out.

You'll also want to pay special attention to the part about applying thread locker and getting the proper torque on the torx bolt.

slow

iTrader: (7)

you need a T47, a T50 and a hammer will work as well, but not reccomended.

Ryan

killagt

iTrader: (3)

U are correct !! I just coming back here just to update the thread, about using T-47 LOL but u beat me to it, T45 is too small, and t50 is just kinda big, T-47 is just right but little loose, I ask the guy over the counter if he have T-48 or T-49 LOL LOL LOL. He say their so such thing is t48 t49 lol.